Because the green laser system has the flexible processing mode, the high precision processing effect as well as the flexible controllable processing process

Long life laser module configuration green laser system has been basically close to the free maintenance, in the production process, laser pens grade 1, no other safety protection device.Blue laser pointer system is equipped with a suction device, will not cause the emissions of harmful substances. The control software with easy operation, the burning laser pointer is being replaced the traditional mechanical process, saving the cost of special tools.green laser1

High power laser circuit board  board and green laser light micro drilling and other fields, the green laser system exhibits a significant technological advantage. According to the thickness of the circuit board of different materials, laser module along the desired contour once or repeatedly cutting. Material is thin, cutting speed faster. If the cumulative laser pens is lower than that of penetrating materials required for blue laser pointer, only scratches on the surface of the material; therefore, can be two-dimensional code or code in the material marking, in order to follow the process of burning laser pointer.

green laser2

The circuit board of the high power laser for frontback connection between the double plate line, or connection circuit for any layer between the conductive multilayer board. In order to need, after drilling the hole wall is plated with a metal layer. Now using the traditional green laser light has been unable to meet the drilling diameter smaller requirements: although improve the spindle speed, but the radial velocity of green laser can be reduced because the diameter is too small, even unable to complete the requirements of the laser module. in addition, considering the economic level, easy to wear laser pens supplies is a limiting factor.green laser3

In the early days, each layer of blue pointer laser circuit has been applied to the multi-layer circuit board.Burning laser pointer through the prepreg is pressed together; according to the circuit design, some regions of the high power laser need to be pressed and then cutting window.